![]() If you don't have them, you can still do turning, so don't dismay. Take a look at these pages and familiarize yourself with the accessories so that when you see one, you know what it is: You should search under / around and over the lathe to see what might be there. You want to get as many accessories as possible. Use it and when you get something better, pass it on to the next guy. If it's cheap enough, I would call it a good starter lathe. Atlas lathe serial numbers how to#You will learn a lot with a lathe like that, and you won't pick up bad habits from powering thru work rather than properly grinding tools for the job - you WILL learn how to grind tools (plenty of resources here on how to do that). Also, being bent drive, it is more forgiving than a gear head lathe - if you stall the lathe the belts will slip and you won't break anything. Remember that if there is a thousanth of wear in the bed, that translates to much less than a thousanth off the diameter of what you are turning, as you are coming down on the side of the work piece.Īs has been said it's a lightweight lathe and can't take heavy cuts, but it can take heavier cuts than not having one at all. It is still usable, but not accurate when turning longer items. If it locks up 6" down the bed, then the bed is pretty worn. The further it goes before that happens the better. Now try to run the carriage to the right. You want to be able to more the carrriage but feel a slight drag. There's a locking bolt on the right top of the carriage - tighten that by hand so that it is just barely snug. To get an idea of bed wear, bring the carriage to the left near the headstock. Note that Gary's lathe is the late 1950's and up "commercial" model, which is MUCH heavier (50% thicker ways) and has a quick change gearbox. Mine is a 1952 and looks a lot different.Īs it doesn't appear to have bearing caps (like the main bearings on a car), it probably has tapered roller bearings in the headstock, which is good. That is either a 12x36 or a 10x36 Atlas lathe from the 1940's or so. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |